DynaVap – Tip / heating chamber

This was my first dynavap experience. Bought the titanium tip with the non-captive cap and combined it with a glass adapter, been using it for a few months now and it performs well with a cheap beaker bong with the downstem removed and no water inside the bong. You can see my whole setup on the attached picture.
First I had only a cheap single flame butane torch, then I’ve built an induction heater for it. I prefer to use it with the IH now, it’s more consistent and faster than heating with a flame.
Since then I’ve bought a complete Vapcam M 2021 version which is made of steel and haven’t noticed any difference in heat up and cooldown times compared to the titanium tip. Note: Titanium is advertised with faster heat up and cooldown time. Of course my measurements are not precise but they both feel the same to me.
My only problem with this tip is the titanium screen it comes with. It is not the right size, smaller than the SS screen and because of this the dosing chamber size cannot be adjusted. I tried to support the screen from below when installing but it never stays in place, falls down to the bottom when I stop supporting it from below. I’ve straightened it on my tabletop but it just does not want to work. The SS screen can be easily set to half-bowl, no matter if I use the titanium or the M2021 SS tips. Take this into account when buying, and get some spare SS screens to if you want to use the half-bowl setting.